Zbtlink INC
Warming:
Before steps finishing, don
’
t cut the power off, or it will break your router.
n
2.3 System Requirements.
Ø
Network card and Ethernet cable
Ø
TCP/TP net software (Windows 95 or higher version has pre-install)
Ø
IE 5.0 or higher version
n
2.4 Install Condition
When you install the router, please refer the below
Ø
Put the device horizontally
Ø
Keep away from any heat device
Ø
Do not put it in some place which is too dirty or too humidity.
Remark
:
The environment will effect the transfer distance , recommend using environment:
Temperature:
0
~40
℃
℃
,
Humidity
:
10%~95% RH
3. TCP/IP Configuration
Before using the device, you need to configure the network correctly, this manual is based
on the Windows 2000/XP, the IP of the device is 192.168.1.1 , subnet mask is 255.255.255.0 .
Firstly, connect your PC to the LAN port, and then you can configure the IP of your PC in 2
ways.
²
Set the IP
Set your PC
’
s IP as 192.168.1.xxx(xxx could be any number in 2~254), subnet mask
to be 255.255.255.0 , default gateway 192.168.1.1 , DNS server 192.168.1.1
²
Auto set the IP by the DHCP server.
Set the TCP/IP to
“
automatically get IP address
”
, after setting , you could use the
Ping command to check if the device has connected to the PC. For an example, in
Windows 2000, run the cmd.exe , and the enter ping 192.168.1.1 If the screen shows as
the below, means OK, the device connected to the PC.
If it shows as below, it means fail
