zBoost ZB450, Руководство пользователя

Страница: 8 / 10

zBoost
®
ZB450 Manual zBoost
®
ZB450 Manual
8 9
zBoost Base Unit Light Indicators
Should you desire to improve coverage, you may:
• Relocate the External Antenna in order to capture a better signal – higher is usually better
and outside is better than inside.
• Increase the distance between the Indoor Antenna and the External Antenna.
• Purchase an upgrade antenna available at www.zBoost.com.
Improving Your Coverage Area
During Initial Power Up
Light Mode Status
Solution
Cycle RED,
GREEN,
ORANGE System is
powering up.
Please allow up
to 30 seconds. N/A
Flashing
GREEN BASE UNIT will
fl ash GREEN
once for every
2 dB less than
optimal system
gain. Three
fl ashes or less
indicates the
system will still
operate properly.
1. Unplug the BASE UNIT power supply.
2. Relocate the EXTERNAL ANTENNA to pick up the
strongest signal from your wireless carrier.
3. Move the EXTERNAL ANTENNA as far away from the
INDOOR ANTENNA as possible, with at least 15 ft. of
vertical separation (height difference).
4. Plug the BASE UNIT power supply back in.
5. Wait 30 secs. for the BASE UNIT to power cycle on.
Solution #1
After Initial Power Up
Light Mode Status
Solution
SOLID
GREEN zBoost is ready. N/A
Flashing
GREEN zBoost is in use. N/A
SOLID
ORANGE EXTERNAL
ANTENNA
and INDOOR
ANTENNA
are too close
together. 1. Unplug the BASE UNIT power supply.
2. Move the EXTERNAL ANTENNA as far away from the
INDOOR ANTENNA as possible, with at least 15 ft. of
vertical separation (height difference).
3. Plug the BASE UNIT power supply back in.
4. Wait 30 secs. for the BASE UNIT to power cycle on.
Solution #2
SOLID RED Signal from the
carrier’s cell
tower is too
strong for the
BASE UNIT to
operate properly.
1. Unplug the BASE UNIT power supply.
2. Relocate the EXTERNAL ANTENNA to another spot.
3. If you have a directional antenna re-aim it to reduce
carrier signal strength.
4. Plug the BASE UNIT power supply back in.
5. Wait 30 secs. for the BASE UNIT to power cycle on.
Solution #3
Flashing
RED Excessive
electronic noise
in the system –
the BASE UNIT
will not operate. ^ Refer to Solution #2