5 | P a g e
ZBOOST® YX520 (INTERNATIONAL) USER GUIDE
Warning
Avoid placing the Signal Aerial near metal such as wiring, A/C
ducts, metal siding, truss plates, etc.
When connecting the cable to the aerial, run the cable straight
down from the aerial. Avoid draping the coax near the aerial.
Determine Coverage Area Needed
Identify the location in your home/office where you need signal coverage the most. The
zBoost® YX520i can cover approximately 250 square meters (coverage varies based on
outdoor signal level, building construction, and placement of aerials). Walls, ceilings or floors
will reduce the coverage area.
FIGURE 4: zBoost® Base Unit Coverage
FIGURE 4: zBoost® Base Unit Coverage
Determine the Location of Signal Aerial and Base Unit Aerial
It is recommended that the Signal Aerial and Base Unit Aerial have approximately
5 meters of vertical separation
.
If the aerials are too close together, the signal light on the Base Unit will flash red indicating a
problem (
See Page 12, Troubleshooting
). To capture the best signal, place the Signal Aerial as
high as possible and position it vertically, keeping it at it at least 1 meter away from any metal.
The location of the Signal Aerial should be at least 5 meters higher than the Base Unit Aerial. If
this is not possible, maximizing the horizontal separation between the two aerials is advised.
See page 6,
Setting Up Your zBoost® Product
, for additional information.
P a g e |
5
ZBOOST® YX520 (INTERNATIONAL) USER GUIDE
Warning
The zBoost® YX-520i Series base unit MUST only be used with
the provided power adapt
e
r. Use of other power adapt
e
rs will
void the warranty and may damage the unit. Use of other
equipment is not CE approved.
Additional Cable Requirements
If the distance between the Signal Aerial and the Base Unit exceeds 17 meters , you will need
to purchase additional coaxial cable for a total coax cable length of 23 meters. You may use
RG-6 coaxial cable and F connectors, which are rated for outdoor satellite TV use and can be
found at many home improvement and electronic stores.
For the best performance, purchase RG-6 low-loss extension cables from our website or your
retailer. The total cable length should not exceed 23 meters unless you also purchase an
upgraded Signal Aerial (
see page vi
). A longer cable is helpful only if it allows you to place the
Signal Aerial in a location where you measure stronger signal.
Grounding the Signal Aerial
If you decide to place the Signal Aerial outdoors, it must be properly grounded. The set up
must be in accordance with electrical codes and standards applicable to your area. A listed
aerial discharge unit must be provided for the lead-in coaxial cable or the shield of the coaxial
cable must be permanently and effectively grounded in accordance with local electrical codes.
Please consult a professional installer or electrician for more information. Additional
instructions and hardware are also available in the zBoost® Outdoor Grounding Kit (
page v
).
Securing Cable with a Drip Loop
FIGURE 5: Securing
Cable with a Drip Loop
If you place the Signal Aerial outdoors, create a drip loop with the
coaxial cable at the point where the cable enters the building
through an outside wall. This can be done by twisting and securing
the cable into a loop (no less than 4cm across) near the entry
point. This will help prevent moisture from gathering at entry
point and leaking into the building. Consult a professional installer
if you need more information. Additional instructions are also
available in the zBoost® Outdoor Grounding Kit (
see page v).
Power Requirements
The power plug has interchangeable adapt
e
rs. Select the adapt
e
r that is compatible for your
geographical area.
Coax
Cable
Exterior Wall
