Zaxcom ZFR400 Setup Menu
19
SETUP MENU
Test Tone
The ZFR400 has an internal tone generator so the signal chain can be properly gain staged. From this menu
pressing the INC key will turn on the tone generator pressing the INC key will cycle trough the different tone
options (500Hz at -20, 1000Hz at -20 or 500Hz at full scale).
Key Lock On Boot Up
This menu sets what happens to the keys on the face of the ZFR400 after boot-up.
LOCKED
- After boot-up has completed, the ZFR400 will automatically lock and the keys will not function.
This is to prevent accidental changes to the settings. To unlock the keys at any time - simultaneously press
the MENU and INC key 5 times.
UNLOCKED
- After boot-up the keys will remain unlocked. In unlocked mode the keys can still be locked
going in to the lock screen in the main menu and wait 5 seconds.
ERX Firmware Update
This menu will only appear if ZaxNet is set to transmit (TX) mode
This menu is used to update the firmware on an ERX receiver. If ZaxNet mode is set to transmit (TX) then
this menu will appear and allow for ERX firmware to be updated.
For complete update instructions see the FIRMWARE section in the back of this manual.
Low Battery Stop
Low battery stop will set the amount of time, after a low battery warning occurs, the ZFR400 will close the
current file and stop recording.
This is to prevent possible file corruption if the unit constantly powers off and on due to a dead battery.
NEVER STOP
- The ZFR400 will not stop recording unless it is manually stopped by a key press, or when it
receives a stop command via ZaxNet or if the battery dies.
Any interval from 1 to 99 minutes
- Once the battery indicator starts blink a low battery warning the ZFR400
will continue to record for the time set here - then it will close the file and stop recording.
LOW BATT STOP:
NEVER STOP
KEY LOCK ON BOOT:
UNLOCKED
TEST TONE: ON
I I I
PRESS TO SEND
ERX PROG FILE
