G: MACHINE INSTALLATION
3.Sanitizing
The machine should be disinfected with the disinfectant separately bought from drugstore or
marketplace according to the instruction manual of the disinfectant and then clean it with water (see
cleaning and draining instruction). Generally this should be done every three months.
4.To remove mineral deposits:
Mix 4 liters water with 200g citric acid crystals, inject into the machine and make sure the water can
flow out of the hot water tap. Switch on the power and heat it about 10 minutes, 30 minutes later,
drain off the liquid and clean it with water for two or three times. Generally this should be done every
six months.
Never disassemble this machine by yourself to avoid danger from damaged machine.
1-2. Loosen the screw of the left or right bottom angle just as the picture
shown.
3.Use the screw to fix the bracket on the left or right bottom angle of the
water dispenser.
4.Make a hole on the floor’s or the desk’s surface where the water
dispenser will be installed.
5.Fix the bracket on the floor by screw tightly.
6.Tighten the screw.
WARNING!
To avoid a hazard due to instability of the appliance, it must be fixed in accordance
with the instructions.
Water dispenser
Bracket
The hole for
tighten screw
5
6
The packaging material used is recyclable; we recommend that you
separate plastic, paper and cardboard and hand them over to recycling
companies. To help preserve the environment, the refrigerant used in
this product is R134a (Hydrofluorocarbon-HFC), which does not affect
the ozone layer and has a low impact on the greenhouse effect.
IMPORTANT INFORMATION ON THE CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2012/19 / EU
Used electrical appliances are valuable materials, which is why their place is not in the garbage! Therefore, please support us and participate in the protection of
natural resources and the environment by handing this device over to the collection centers or to the importer whose address you can find in this manual or in the
warranty certificate. By removing household appliances separately, you will avoid any negative consequences that incorrect disposal could have on the environment
and health, and you will allow the use of constituent materials to save energy and resources. Additional details can be requested from the local administration or at
the nearest collection point. Improper disposal of waste may, in accordance with national regulations, be amended. Separate decommissioning of an appliance is
specified by marking the product with the image of a cut bin.
This product does not contain environmentally hazardous materials (lead, mercury, cadmium, hexavalent chromium and brominated flammable agents: PBB and PBDE).
We assume the right to make changes to these provisions without further notice.
SC ZASS ROMANIA S.R.L. is not responsible for any typographical errors, images or product characteristics.
COMPLIANT
w w w . z a s s r o m a n i a . r o
