2
B.GETTING STARTED
Locate Dispenser
1. Place dispenser upright.
2. Locate dispenser on a hard and level surface in a cool shaded
location near a grounded wall outlet.
Notice: Do NOT plug in power cord yet.
3. Position dispenser so the back is at least 20cm from wall and
there are at least 20cm of clearance on both sides.
3 Gallon Bottle
5 Gallon Bottle
Collar
Collar
Head
Head
Install Water Bottle
1. Open dispenser door.
2. Place probe assembly on probe hanger.
3. Place fresh bottle outside of cabinet.
4. Remove entire plastic cap from top of bottle.
5. Clean outside of new bottle with a cloth.
6. Place probe into bottle.
7. Slide collar down until it clicks in place.
8. Push head down until tubes hit bottom of bottle.
9. Slide bottle into cabinet and close door.
Provide Electricity
Plug cord into a properly grounded wall outlet. At this time the pump
will begin to move water from the bottle to the hot and cold tanks.
It will take up to 12 minutes to fill the tanks for the first time.
During this period the pump will run continuously. This is normal.
Activate Heating & Cooling
Notice: This unit will not dispense hot or cold water until the switches are activated.
To activate, push top side of power switches in to start heating and cooling water.
- If you do not want to heat water, push bottom side of red switch in.
- If you do not want to cool water, push bottom side of green switch in.
•Do not store explosive substances such as aerosol cans with a flammable propellant in this
appliance.
•This appliance should work under environment of temperature from 4~40°C
humidity ≤90%.
•This appliance is not suitable for installation in an area where a water jet could be used.
•Never turn the machine upside down or lean it more than 45°.
•When the machine is under the ice point and blocked by ice, the cooling switch must be closed
for 4 hours before turning it on again to continue its operation.
•This machine should not be turned on until 3 minutes later after turning off the power switch.
•WARNING: Do not locate multiple portable socket-outlets or portable power supplies at the rear
of the appliance.
•It is recommended to use bottled pure water. If you use hard water, may lead to hot pot furring
or detonation tank or pipeline risk. If you need cleaning tube, remove scale, need to find a
professional institutions and professional operation.
•This product is not recommended to use in areas above 2,500m altitude.
•The appliance must not be immersed