1.
Handset Channel selection (the same operating channel must be selected on gatestation and
all handsets)
Take out battery from handset, keep K1 pressed in while inserting the battery, the unit will
enter channel selection mode. Press K7 and K9 to select the preferred channel then take out
battery again. Install back battery and press K2 to switch on unit.
2.
Handset Pairing mode (Place the handsets and gatestation on a flat surface such as table
when doing pairing)
Take out battery from handset, keep K4 pressed in while inserting the battery, the unit will
enter pairing mode and the LCD will show a “P” flashing. Now place the handset near to a
gate station on a flat surface.
3.
Gatestation into Pairing mode
Take off the aluminum plate. Press and hold in the PAIRING button before connecting to
any power supply. Now connect the power supply or back-up battery connector. After
around 7 sec, the two Button LEDs will light up, indicating the gate station has entered into
pairing mode. Now the PAIRING button can be released.
4.
Pairing
Once both the handset (handsets if more than one is needed per button) and gatestation are
in pairing mode, press button 1. The handset’s screen will show 001 after a few seconds
and two beeps will be heard on the gate station once the pairing process is successful.
The two button LEDs continue to light up, indicating the gate station remains in pairing
mode. Set another handset in pairing mode, press button 2, the handset’s screen will show
002 after a few seconds and 2 beeps will be heard on the gate station. Disconnect power
supply and reconnect again, the two button LEDs will go off, indicating the gate station is
now under normal operation mode.
K6 Call alert select button
K4 Lock A button
K5 Lock B button
K3 Call reply/ Calling gate station button
K2 Hang Up/Power ON/OFF button
K1 Handset calling button
K8 Ringing tone time select button
K7 Volume up button
Doorbell visual light
Microphone
Speaker
K9 Volume down button