USB Output:
A standard USB output enables other devices to be recharged. Plug in the
devices USB charging cable into the USB output and charging will start
automatically. The battery level indicator lights will display and reduce levels
during charging.
WARNING!
•
Fully charge the worklight before storing for long periods. Keep recharging
every few months or the battery may go faulty.
•
Do not recharge this worklight with any other adaptors other than those
recommended.
•
Do not dispose of the worklight in a fire or ordinary waste.
•
Do not operate the worklight in high temperature, hazardous or explosive
environments.
•
Do not subject the worklight to strong impacts.
•
Do not disassemble or modify the worklight as it contains protective
devices which, if damaged, may cause the battery to heat or ignite.
•
Do not leave the worklight in direct sunlight or hot spaces for extended
periods.
•
Never short circuit, reverse polarity, disassemble, damage or heat the
battery packs over 100°C. If an exploded Li-ion battery does ignite, it will
burn more violently if it comes into contact with water or moisture. Never
put water on a burning Li-ion battery only use a fire extinguisher.
•
This worklight is rain and splash proof only but not submersible. If the
worklight gets submersed in water, immediately dry the worklight and do
not use for a few days. Water damage is usually irreparable.
Operation:
The on/off button is located at the back of the unit. Press multiple times to
change modes. Press button once to check battery level. Battery life will depend
on the brightness of the beam. Battery lights will switch off after 5 seconds.
The Zartek ZA-448 worklight has a durable rubberised lightweight housing with a
foldable stand and handle for either positioning on flat surfaces or carrying.
There are 2 screw-in attachments included for various mounting methods.
