zarges ZAP Z600, Инструкция по сборке и эксплуатации

Страница: 7 / 16

6
> When calculating safety clearances, allow for the swinging radius of power
lines and the movement radius of working personnel. The movement radius in-
cludes any objects held by personnel.
> If it is not possible to comply with the safety clearances, have the operating
authority disconnect the power lines and secure them against being switched
back on.
3. Technical description
3.1 Scope of
delivery
The scope of delivery varies and depends on the specific order.
• Before starting assembly of the product, check that all components listed in the
order confirmation and on the delivery note have been supplied and are in perfect
condition. For assembly, use only original parts that are free from defects.
3.2 Type plate For identification of the specific model supplied, see the type plate. The type plate is
attached to the outside of the side platform profile section. Replace the type plate if
it becomes illegible.
Explanation of the pictograms:
220 kV – 380 kV
or if the rated voltage is not known 5.0 m
Rated voltage (V) Safety clearance (m)
1 Carry out visual inspection before use.
2 Maximum total permissible load = 150 kg.
3 Do not use on surfaces which are uneven or of insufficient load-bearing
capacity.
4 Do not use the product if there are slippery substances on it.
5 Do not subject the equipment to one-sided loads.
6 Do not climb on the guardrails.
7 Do not lean over the guardrails.
8 Always face the steps when climbing down.
9 Do not set the product up directly next to a door.
10 Do not use the product to climb onto an adjacent building or vehicle.
1 2 3 4 5 6 7 8
16 15 14 13 12 11 10 9