zarges Skymaste Industrial Z600, Инструкции по сборке и использованию

Страница: 6 / 32

Assembly and usage instructions
Z600 brace-free mobile scaffold towers
6
2. Setup
2.1. Safety provisions
1. The stipulations of EN 1004 “Mobile work platforms” apply to the structural safety,
erection and use of the aforementioned scaffold towers.
2. The scaffold towers may only be set up and used by persons familiar with these
assembly and usage instructions.
3. At least two persons are required to set up or dismantle the scaffold tower.
4. Undamaged and fault-free original spare parts for the manufacturer's
scaffolding system to which the test certificate applies must be
used. Before using the scaffold tower, all parts must be examined
for correct assembly and functionality.
5. The maximum platform heights as defined by EN 1004 are
8 m outdoors and 12 m in fully enclosed spaces. For the
scaffold towers described in these assembly and usage
instructions, the maximum platform height in fully enclosed
spaces is 10 m.
6. The use of lifting tackle on the scaffold tower is not permissible.
7. The first platform must not be more than 4.40 m above floor level. The distance between
further platforms must not exceed 4 m. The platforms must be at least 1.70 m apart.
8. When setting up or dismantling scaffold towers, platforms or scaffold planks must be
laid out over the entire area at a distance of 2 m as an aid to assembly/dismantling.
Where scaffold planks are used, they must extend 500 mm beyond the scaffold tower
on each side. Standing on railings and braces is prohibited, even during setup and
dismantling.
9. The scaffold tower may only be set up in vertical
position on a horizontal, level surface of sufficient load-
bearing capacity. Where necessary, load-distributing
pads must be used.
10. Chassis beams, ballast weights, stabilisers and stand-off brackets must be used to
ensure structural safety as described in these assembly and usage instructions.
11. Working on the work platform is only permissible with full protection on 3 sides,
i.e. guard-rail frame, knee protection and peripheral toeboards. Toeboards are not
necessary on the rest platforms.
12. Working on several work platforms simultaneously is prohibited.