zarges MultiTower S-PLUS 1T, Инструкции по сборке и использованию

Страница: 7 / 42

7
en
13. Work on the working platform is only permitted with complete 3-part side
protection, i.e. guard-rail frames, knee protection and peripheral toeboards.
Toeboards are not necessary on the rest platforms.
14. When setting up the scaffold unit against a wall, stand-off brackets can also
be used in addition to ballast (accessory, Order No. 42920).
15. Working on several working platforms simultaneously is not permitted.
16. The permissible load capacity of the scaffold unit with evenly-distributed load
is 2.0 kN/ m² (in accordance with EN 1004-1 – scaffolding category 3).
17. Moving the scaffold unit with the assistance of vehicles (e.g. fork lifts) is
prohibited. The scaffold unit must not be lifted, pulled or pushed using a
fork lift.
18. Bridging the gap between scaffold units and buildings by means of planks
etc. is not permitted.
The scaffold unit must not be used as a stair tower to reach other
constructions.
19. For use outdoors or in open buildings, the scaffold unit must be moved into a
wind-protected area where wind strengths exceed 6 (on the Beaufort scale),
in the case of an oncoming storm and when work has been completed,
or it must be protected against tipping with other suitable measures
(e.g. anchoring). At wind strengths exceeding 6 on the Beaufort scale (12m/s),
it becomes perceptibly difficult to walk forwards.
20. Before using the scaffold unit, its vertical alignment must be checked and
corrected if necessary.
21. The scaffold unit must be checked for correct and complete set-up.
22. The scaffold unit must not be used during lightning and thunderstorms.
23. Mobile work platforms must not be used as roof-edge protection.
2.2 Usage regulations
24. Personnel must ascend to work platforms from the inside only. Ascending
from the outside is only permitted up to platform heights of 2 m.
25. Personnel must not brace themselves against the side panels while working.
26. Jumping on the platforms is prohibited.
27. The generation of horizontal loads which could cause the scaffold unit to tip
over, for example through work on adjacent constructions, is prohibited.
28. Particular attention must be paid to wind conditions which might cause the
scaffold unit to tip over when it is used in buildings open to the passage of
wind, in uncovered buildings or at the corners of buildings.
6 BFT