5
USE aS a STUn gUn
USE A ZAP
®
STUN GUN oNly AS A DEfENSiVE wEAPoN. This product is
suitable to be carried at all times, including walking, jogging, hiking, bicycling,
entering or leaving buildings, etc. The ZAP
®
should only be used when you
would be justified to prevent an unwanted encounter.
TURN oN/off SwiTch To oN. Push Stun Activation Trigger to discharge.
Keep your hands and other body parts away from stun electrodes, as severe
shock may occur.
A ShoRT blAST (1/4 second) will startle an attacker, cause minor muscle
contractions and can have a repelling effect.
A MoDERATE blAST (1 - 4 seconds) can cause attacker to fall and can cause
mental confusion. It may make the assailant unwilling to continue attack, but
they will be able to get up almost immediately.
A fUll blAST of 5 seconds or more can immobilize an attacker, causing
disorientation, loss of balance, falling to the ground, weakness
and leaving them dazed for several minutes afterwards.
ThE ZAP
®
chARGE will have an effect anywhere on the body, but
the maximum effect is in areas marked with an "X" in the drawing.
While using a ZAP
®
Stun Gun, you cannot suffer a charge-back to
your own body, even if the attacker is holding you.
bATTERiES: Test fire your ZAP
®
Stun Gun periodically for
familiarity, performance and reliability. You should replace
batteries when electrical arc gets weak.
Always keep stun guns out of the reach of children. Keep away from
flammable gasses, as an explosion may occur. Must be 18 to purchase. iD
check required. check state and local laws regarding product usage.
X
X
X
X
X X
X
X
2
YOUr ZaP gUn
TM
3
USE aS a flaShlighT
Stun Activation
Trigger
Zap Electrode
LED
Flashlight
Zap
Electrode
Stun Ready
Indicator Light
ON/OFF
Switch
Battery Cover
• Turn on the LED flashlight by
pushing the on/off switch to
middle position.
oN / off SwiTch:
STUN-READy
iNDicAToR liGhT
• When ON/OFF Switch is in
Stun-Ready (DOWN) position,
the red Stun-Ready light
comes on to indicate the unit
is ready for use.
DowN position:
STUN READY
MiDDlE position:
FLAShLIGhT ONLY
UP position:
POWER OFF
4
BaTTEriES
NoTE: batteries may be covered with
a clear plastic film for protection
during shipping. This plastic must be
removed for proper battery function.
before using first time
• Make sure your ZAP
®
Stun Gun is switched
to power-off position before installing the
batteries.
• Open battery cover and install 3 new lithium
CR2 batteries, noting the correct polarity.
Replace the battery cover.
Replacement of batteries
• When the electric arc of your ZAP
®
Stun Gun
gets weak, it is time to replace the batteries.
• Always use CR2 lithium batteries. For best
performance, use genuine ZAP
®
brand
batteries.
