SAFETY WARNINGS
THE PURPOSE OF SAFETY SYMBOLS IS TO ATTRACT YOUR ATTENTION TO POSSIBLE DANGERS. THE
SAFETY SYMBOLS, AND THE EXPLANATIONS WITH THEM, DESERVE YOUR CAREFUL ATTENTION AND
UNDERSTANDING. THE SAFETY WARNINGS BY THEMSELVES DO NOT ELIMINATE ANY DANGER. THE
INSTRUCTIONS OR WARNINGS THEY GIVE ARE NOT SUBSTITUTES FOR PROPER ACCIDENT PREVENTION
MEASURES.
Failure to obey a safety warning can result in injury to yourself or others. Always follow the safety precautions to reduce the risk of fire,
electric shock and personal injury.
1. Read and understand this owner's manual before using this unit. Be thoroughly familiar with the proper use of your Xebra.
2. Thoroughly inspect your Xebra for loose or damaged parts before each use. If there are any loose or damaged parts, have a
technician perform the needed adjustments or repairs before starting your Xebra.
1. You should not smoke while operating a Xebra. Keep the Xebra away from open flames such as lighters, etc. Never smoke while
charging.
2. The operator must know and obey all local laws concerning the operation of, and equipment requirements of, electric vehicles.
Make sure that your equipment and operation of your electric vehicle meets these standards. Failure to obey these laws may result in
severe injury or death.
3. AVOID UNINTENTIONAL STARTING - Do not leave the Xebra with the key in the ignition when not in use.
4. DO NOT disassemble the motor controller. Return the Xebra to your authorized service dealer for service or repair.
5. DO NOT wash the exterior of the car with the center headlight on! The light gets very hot and immersion with cold water can crack
the glass.
PRE-OPERATIONAL SAFETY WARNINGS
GENERAL WARNINGS
23
Owner
’
s Manual
BATTERY WARNINGS
CHARGER WARNINGS
1. To reduce the risk of injury, use only batteries provided or recommended by ZAP. Other batteries may explode causing personal
injury and damage.
2. DO NOT PLACE THE BATTERY NEAR FIRE OR HEAT. It could explode.
3. Batteries can emit explosive gases while being charged. Read the instructions supplied before attempting to charge your battery.
4.
1. Before charging, read the applicable sections, including BATTERY Charger, Battery Maintenance and Power Cord.
2. USE ONLY THE APPROVED GAUGE POWER CORD with your Xebra. Use of any other cord could cause the battery to explode,
causing serious injury.
3. Do not expose the charger to moisture or water.
4. To reduce the risk of damage to the charger and cord, disconnect the charger by taking the plug
in hand and pulling it out of the wall. Don't disconnect it by pulling on the cord.
5. Make sure the cord is located so that it will not be stepped on, tripped over, or otherwise be subject to damage or stress.
6. An improper extension cord could result in fire or electric shock. If you must use an extension cord ensure that:
a. The pins on the plug of the extension cord are the same number as the charger. It must be grounded.
b. The extension cord is the proper size for the amperage and in good electrical condition.
7. If the cord or plug is damaged, replace the cord completely.
8. Do not operate the Xebra if it has received a sharp blow, been struck, or been damaged in any way.
9. Do not disassemble the charger. The charger is not serviceable. Disassembly may result in electric shock or fire.
10. To reduce the risk of electric shock, unplug the charger from the outlet before cleaning the Xebra
11. It is ideal to charge in dry or sheltered conditions. Charging in heavy rain or precipitation may lead to mechanical or personal harm.
12. Charge in a well-ventilated area away from sparks, flames and smoking areas.
13. For optimum performance, your Xebra should be charged in a location where the temperature is more than 50 deg. F (10 deg. C)
but less than 100 deg. F (37 deg. C). See BATTERY MAINTENANCE.
PERIODICALLY BE SURE ALL BATTERY CONNECTORS ARE TIGHT!
24
Owner
’
s Manual
