Installation Guide
RS-
GM
6
* For automatic transmission vehicles only
•
This remote start will monitor the vehicle lock circuit and use the pulses generated by pressing
Lock>Unlock>Lock
on
your
OEM
remote to start the vehicle.
•
This is a pre-wired
"
plug
&
play
"
kit.
No wiring is required f
or basic
installation.
•
We have already loaded the correct
firm
ware into the remote start module. You will need to pair the
module to your
vehicle
when the
wiring
is complete. Instructions are on page
4
.
There are
6
basic steps to this remote start installation. We’re going
to address each of these:
1.
Download and install Flash Link Manager software
2. Locate the BCM
connectors
under the dash (no disassembly required)
3. Plug the connectors in to the vehicle.
4.
Pair the remote start to the vehicle.
5.
Test the system
and r
ecord your Service Number
6.
Button it up!
Step 1: Download and install Flash Link Manager software
The Flash Link Manager (FLM) software only works on a Windows computer
, then download and install the software
https://fortin.ca/en/support/flashlinkmanager.html
Next, open the software and log in with the following credentials:
email: [email protected]
password: Flash2020
Once the (FLM) software installed and open, then connect the Flash Link Lite (FLL) to the USB port of your Windows
computer. The (FLM) software will detect (FLL) and display a message that the module is not connected
, this is normal
. Do
not plug the remote starter into the (FLL) tool until you have completed the
wiring and
vehicle programming procedure at
step 3. Leave the computer and software in this state ready to plug the module in when the time
comes, and proceed with
the wiring connections.
REV
01132021
You may view a high-resolution
color version of this guide online
at
http://install.kleinn.com/
RSGM
6
1
|
P a g e
Overview
Silverado 1500 2019
Suburban
201
5
-2019
Tahoe
201
5
-2019
CHEVROLET
Sierra 1500
2019
2018-2020
Terrain
Yukon
201
5
-2019
GMC
