Fig. 4
1
2
c) Mounting the door
Fix the hinges to the appliance by means of the
M5x15 screws. The hinges can be adjusted to
compensate for possible uneven thickness of
the door.
To align the door perfectly it is necessary to
loosen the screw, adjust the door and tighten
the screw
A
again (Fig.
5
).
Warning!
Do not remove the screw
B
(Fig.
5
).
Fig. 5
B
A
d) Counter-magnet
The appliance is prearranged for a magnetic
closure of the door.
To enable a correct operation of this device, it
is necessary to screw the counter-magnet
A
(steel disk + rubber ring) into the inner side of
the door. Its position must correspond to the
magnet
B
on the appliance (Fig.
6
).
Warning!
Do not remove the screw
C
.
Fig. 6
A
B
C
If the door has to be opened from left to right,
invert the position of the plates
E
, the magnet
D
and the plate
C
. Mount the counter-magnet
D
and the hinges
A
as previously described (Fig.
7
).
Warning!
Do not remove the screw
B
.
Fig. 7
A
B
C
E
D
Electrical connection
Information on the electrical connection is given
on the rating plate on the inner edge of the ap-
pliance door.
Check that your domestic electrical installation
can take the maximum load required, also tak-
ing into account any other appliances in use.
Caution!
Connect the machine to an
earthed socket.
Caution!
The manufacturer does not
accept any responsibility for damage
or injury through failure to comply with
the above safety precaution.
Caution!
The power supply cable
must be easily accessible after
installing the machine.
28
www.zanussi.com
Содержание ZWT 71401 WA
Страница 1: ... 1 8VHU PDQXDO HQXW HULQIRUPDWLRQ DVKHU GU HU DVFK 7URFNQHU 7 ...
Страница 62: ...62 www zanussi com ...
Страница 63: ...63 www zanussi com ...
Страница 64: ...www zanussi com shop 132915991 A 272015 ...
