Zanussi ZWG 6165, Руководство пользователя, Страница: 23 / 28

works for treatment before being discharged safely into
a river.
It is essential that these appliances are not connected to
the surface water drainage system as this water is dis-
charged directly into a river or stream and may cause
pollution.
If you require any further advice please contact your lo-
cal water authority.
SHOWER
WASHING
MACHINE
DISHWASHER
BATH
SINK TOILET
BIDET
RAINWATER
‘RUN-OFF’
SURFACE WATER
DRAINS & SEWERS
UNTREATED
DISCHARGE
RIVER RIVER
TREATED DISCHARGE
FOUL DRAIN
FOUL SEWERS
SEWAGE TREATMENT
WORKS
Electrical connection
Any electrical work required to install this appliance
should be carried out by a qualified electrician or com-
petent person.
Warning! THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability should
this safety measure not be observed.
Before switching on, make sure the electricity supply
voltage is the same as that indicated on the appliance’s
rating plate.
Warning! Information on the electrical connection
is given on the rating plate on the inner edge of
the appliance door.
The appliance is supplied with a 13 amp plug fitted.
In the event of having to change the fuse in the plug sup-
plied, a 13 amp ASTA approved (BS1363/A) fuse must
be used.
Should the plug need to be replaced for any reason, pro-
ceed as described below.
The wires in the mains lead are coloured in accordance
with the following code:
1
2
3 4
1 Green & Yellow
2 Brown
3 Cord clamp
4 Blue
The wire coloured green and yellow must be connected
to the terminal marked with the letter «E» or by the
earth symbol or coloured green and yellow.
The wire coloured blue must be connected to the termi-
nal «N» or coloured black.
The wire coloured brown must be connected to the ter-
minal marked «L» or coloured red.
Upon completion there must be no cut, or stray strands
of wire present and the cord clamp must be secure over
the outer sheath.
Warning! A cut off plug inserted into a 13 amp
socket is a serious safety (shock) hazard.
Ensure that the cut off plug is disposed of safely.
Should the appliance power supply cable need to be
replaced, this must be carried out by our Service Force
Centre. The appliance should not be connected to the
electrical supply by means of an extension cable.
Note!
When the appliance is installed the power supply cable
must be accessible.
Permanent connection
In the case of permanent connection it is necessary that
you install a double pole switch between the appliance
and the electricity supply (mains), with a minimum gap
of 3 mm between the switch contacts and of a type suit-
able for the required load in compliance with the current
electrical regulations.
The switch must not break the yellow and green earth
cable at any point.
23