Zanussi ZWG 6165, Руководство пользователя, Страница: 21 / 28

Open the porthole and re-
move the polystyrene
block fitted on the door
seal.
Fill the smaller upper
hole and the two large
ones with the correspond-
ing plastic plug caps sup-
plied in the bag contain-
ing the instruction book-
let.
Positioning
Install the machine on a flat hard floor. Make sure that
air circulation around the machine is not impeded by car-
pets, rugs etc. Check that the machine does not touch
the wall or other kitchen units. Level the washing ma-
chine by raising or lowering the feet. The feet may be
tight to adjust as they incorporate a self locking nut, but
the machine MUST be level and stable.
Any necessary adjustment can be made with a spanner.
Accurate levelling prevents vibration, noise and displace-
ment of the machine during operation. Never place card-
board, wood or similar materials under the machine to
compensate for any unevenness in the floor.
If necessary, check the
setting with a spirit level.
Water inlet
Warning! This appliance must be connected to a
cold water supply
Caution! Before connecting up the appliance to
new pipework or to pipework that has not been
used for some time, run off a reasonable amount of
water to flush out any debris that may have collected
Caution! Do not use the hose from your previous
appliance to connect to water supply.
The inlet hose is screwed to the back of the appliance.
Connect the hose to a tap
with a 3/4” thread. Al-
ways use the hose sup-
plied with the appliance.
35°
45°
The other end of the inlet hose which connects to the
appliance can be turned as showed in the picture.
Do not place the inlet hose downwards. Angle the
hose to the left or right depending on the position of
your water tap. Set the hose correctly by loosening
the ring nut. After positioning the inlet hose, be sure
to tighten the ring nut again to prevent leaks.
Caution! The inlet hose must not be lengthened.
If it is too short and you do not wish to move the
tap, you will have to purchase a new, longer hose
specially designed for this type of use.
Warning! Installation should comply with local
water authority and building regulations’
requirements.
The appliance must be connected to a cold water
supply.
A minimum water pressure of 0.05 MPa (0.5 bar) is
required for safe operation of the appliance.
If you cannot make the cold water connection direct
from the rising mains, you may be able to operate the
appliance from your cold water storage system.
There should be a minimum vertical distance of 5.02 m
(16.5 ft) between the appliance’s inlet and the bottom of
the water storage tank.
21