Zanussi ZWF7040BXV, Руководство пользователя

Страница: 14 / 44

INTERRUPTING A PROGRAMME AND
CHANGING THE OPTIONS
You can change only some options before the
programme carries them out.
1. Press the Start/Pause
button to interrupt
the running programme.
The related indicator flashes.
2. Change the options.
3. Press the Start/Pause
button again.
The programme continues.
CANCELLING A RUNNING PROGRAMME
1. Turn the programme knob to position to
cancel the programme and to deactivate the
appliance.
2. Turn the programme knob again to activate the
appliance. Now, you can set a new washing
programme.
Before starting the new programme
the appliance could drain the water. in
this case, make sure that the detergent
is still in the detergent compartment, if
not fill the detergent again.
OPENING THE DOOR WHEN THE DELAY
START OPERATES
While the delay start operates, the appliance door
is locked and the display shows the indicator
.
1. Press Start/Pause to pause the appliance.
2. Wait until the door lock indicator goes off.
3. Open the door.
4. Close the door.
5. Press Start/Pause
again.
The delay start continues to operate.
OPENING THE DOOR WHEN THE
PROGRAMME OPERATES
While the programme operates, the appliance door
is locked and the indicator
appears.
CAUTION! If the temperature and
level of the water in the drum are too
high, you cannot open the door.
1. Turn the programme knob to position to
deactivate the appliance.
2. Wait some minutes until the indicator goes
off and then open carefully the appliance door.
3. Close the appliance door.
4. Set the programme again.
AT THE END OF THE PROGRAMME
• The appliance stops automatically.
• The acoustic signal operates (if it is activated).
• In the display three flashing zeros come on.
• The indicator of the Start/Pause
goes off.
• The door lock indicator goes off.
• You can open the door.
• Remove the laundry from the appliance. Make
sure that the drum is empty.
• Close the water tap.
• Turn the programme knob to the position to
deactivate the appliance.
• Keep the door ajar, to prevent the mildew and
odours.
The washing programme is completed, but
there is water in the drum:
• The drum turns regularly to prevent the creases
in the laundry.
• The door lock indicator is on. The door
stays locked.
• You must drain the water to open the door.
To drain the water:
1. Turn the programme knob to spinning or
draining programme.
2. Press the button Start/Pause . If necessary,
decrease the spin speed.
The appliance spins and drains or only drains.
3. When the programme is completed and the
door lock indicator goes off, you can open
the door.
4. Turn the programme knob to the position to
deactivate the appliance.
The appliance drains and spins
automatically after approximately 18
hours (except for Wool programme).
STAND-BY
Once the programme has finished, after a few
minutes the energy saving system will be enabled.
The brightness of the display is reduced.
By pressing any button the appliance will come out
of the energy saving status.
14