Zanussi ZU 7115, Инструкция пользователя

Страница: 16 / 20

16
Door reversibility
Remove the two screws which fix the upper hinge to
the door.
Carefully lean the appliance on its back and remove
the plastic insert.
Remove the two screws which fix the lower hinge to
the door.
Remove the four screws which fix the lower hinge to
the base of the appliance and remove the hinge
itself; be very careful to recover all the screws.
Remove the four screws that fix the upper hinge to
the appliance and remove the hinge itself.
Take the hinge removed from the upper part of the
appliance on the opposite side, and, using the
screws removed from the lower part, fix it to the base
of the appliance itself.
Remove and refit the other hinge on the upper part
of the appliance on the opposite side.
Fix the two front screws into the upper and lower
hinges.
Finally, check the alignment of the door and make
sure it closes properly.
After having reversed the opening direction of the
door, discard the original plastic insert removed and
fit the insert supplied with the appliance on the
opposite side
.
Fitting a decorative door panel
Import ant: The components needed to fit the
decorative panel have been pre-fitted on the
appliance.
The brackets are secured to the panel by means
of the 7 ¯ 3.5x13 screws supplied. Before
starting to fit the panel, remove the large top
bracket by unscrewing the screws and adjusting
pins pre-fitted on the appliance door.
The small bottom bracket need not be removed.
Place the appliance in the position where it is to be
built in.
The appliance is fitted with adjustable feet; screw the
front and rear feet in or out to adjust the height of the
appliance to that of the recess. Keeping the
appliance central in the recess, slide it in until its
back touches the wall.
Wõth a tape measure (or similar instrument),
measure distance (A) between the top edge of the
door and the top edge of the decorative panel,
placing it next to the recess.
D447
D510
D467
= =
A