Zanussi ZSLN2321, Руководство пользователя

Страница: 10 / 24

All the consumption values mentioned
in this section are determined in
accordance with the currently
applicable standard in laboratory
conditions with water hardness
2.5mmol/L according to the
2019/2022 regulation (water softener:
level 3).
The pressure and the temperature of
water as well as the variations of the
mains supply can change the values.
THE RINSE AID LEVEL
The rinse aid helps to dry the dishes without
streaks and stains. It is automatically released
during the hot rinse phase. It is possible to set the
released quantity of rinse aid.
When rinse aid chamber is empty, the rinse aid
indicator is on notifying to refill rinse aid. If the
drying results are satisfactory while using multi-
tablets only, it is possible to deactivate the
dispenser and the indicator. However, for best
drying performance, always use rinse aid and keep
the rinse aid indicator active.
To deactivate the rinse aid dispenser and indicator,
set the level of rinse aid to 0.
END SOUND
You can activate an acoustic signal that sounds
when the programme is completed.
Acoustic signals sound also when a
malfunction of the appliance occurs. It
is not possible to deactivate these
signals.
AIRDRY
AirDry improves the drying results. The appliance
door opens automatically during the drying phase
and remains ajar.
AirDry is automatically activated with all
programmes other than Pre-rinse.
CAUTION! Do not try to close the
appliance door within 2 minutes after
automatic opening. This can cause
damage to the appliance.
CAUTION! If children have access to
the appliance, we advise to deactivate
AirDry. The automatic opening of the
door may pose a danger.
KEY TONES
The buttons on the control panel make a click
sound when you press them. You can deactivate
this sound.
SETTING MODE
How to enter setting mode
You can enter setting mode before starting a
programme. You cannot enter setting mode while
the programme is running.
To enter setting mode, press and hold
simultaneously 30 min and ECO for about 3
seconds.
• The light related to and the indicator
flash.
• The indicators , and are on.
• The lights related to the programme buttons
are on.
How to navigate in setting mode
You can navigate in setting mode using programme
buttons.
B A C
A. Previous button
B. OK button
C. Next button
Use Previous and Next to switch between the
basic settings and to change their value.
Use OK to enter the selected setting and to
confirm changing its value.
10