Zanussi ZRB34315WA, Руководство пользователя

Страница: 10 / 16

Important! Do not pull, move or damage any
pipes and/or cables inside the cabinet.
Never use detergents, abrasive powders, highly
perfumed cleaning products or wax polishes to
clean the interior as this will damage the surface
and leave a strong odour.
Clean the compressor at the back of the appli-
ance with a brush. This operation will improve
the performance of the appliance and save
electricity consumption.
Important! Take care of not to damage the
cooling system.
Many proprietary kitchen surface cleaners con-
tain chemicals that can attack/damage the plas-
tics used in this appliance. For this reason it is
recommended that the outer casing of this ap-
pliance is only cleaned with warm water with a
little washing-up liquid added.
After cleaning, reconnect the equipment to the
mains supply.
Defrosting the refrigerator
Frost is automatically eliminated from the evapo-
rator of the refrigerator compartment every time
the motor compressor stops, during normal use.
The defrost water drains out through a drain
hole into a special container at the back of the
appliance, over the motor compressor, where it
evaporates.
It is important to peri-
odically clean the de-
frost water drain hole
in the middle of the
refrigerator compart-
ment channel to pre-
vent the water over-
flowing and dripping
onto the food inside.
Defrosting of the freezer
The freezer compartment of this model, on the
other hand, is a "no frost" type. This means that
there is no buildup of frost when it is in opera-
tion, neither on the internal walls nor on the
foods.
The absence of frost is due to the continuous
circulation of cold air inside the compartment,
driven by an automatically controlled fan.
Troubleshooting
Caution! Before troubleshooting,
disconnect the power supply.
Only a qualified electrician or competent person
must do the troubleshooting that is not in this
manual.
Important! There are some sounds during
normal use (compressor, refrigerant circulation).
Problem Possible cause Solution
The appliance is noisy. The appliance is not installed prop-
erly. Check if the appliance stands stable
(all the feet should be on the floor).
The appliance does not op-
erate. The plug is not connected to the
mains socket correctly. Connect the plug to the mains socket
correctly.
The appliance has no power. There
is no voltage in the mains socket. Connect a different electrical appli-
ance to the mains socket.
Contact a qualified electrician.
The light device does not
work. The light device is in stand-by. Close and open the door.
The unit is defective. Refer to "Replacing the control unit".
The compressor operates
continually. The temperature is not set correctly. Set a higher temperature.
10
www.zanussi.com