![background image](http://html.mh-extra.com/html/zanussi/zra33400wa/zra33400wa_user-manual_938963008.webp)
Problem
Possible cause
Solution
Water flows on the
ground.
The melting water outlet does not
flow in the evaporative tray above
the compressor.
Attach the melting water outlet to
the evaporative tray.
There is too much frost
and ice.
Products are not wrapped proper-
ly.
Wrap the products better.
The door is not closed correctly.
Refer to "Closing the door".
The Temperature regulator may be
set incorrectly.
Set a higher temperature.
The temperature in the ap-
pliance is too low.
The Temperature regulator may be
set incorrectly.
Set a higher temperature.
The temperature in the ap-
pliance is too high.
The Temperature regulator may be
set incorrectly.
Set a lower temperature.
The door is not closed correctly.
Refer to "Closing the door".
The product temperature is too
high.
Let the product temperature de-
crease to room temperature before
storage.
Many products are stored at the
same time.
Store less products at the same
time.
The temperature in the re-
frigeration is too high.
There is no cold air circulation in
the appliance.
Make sure that there is cold air cir-
culation in the appliance.
The temperature in the
freezer is too high.
Products are too near to each oth-
er.
Store products so that there is cold
air circulation.
The appliance does not
operate.
The appliance is switched off.
Switch on the appliance.
The mains plug is not connected
to the mains socket correctly.
Connect the mains plug to the
mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
Connect a different electrical appli-
ance to the mains socket. Contact a
qualified electrician.
The lamp does not work.
The lamp is in stand-by.
Close and open the door.
The lamp is defective.
Refer to "Replacing the lamp".
If your appliance is still not working properly
after making the above checks, contact the Af-
ter Sales Centre.
Replacing the lamp
1. Disconnect the appliance.
2. Push the movable part to unhook the lamp
cover (1).
3. Remove the lamp cover (2).
4. If needed replace the lamp with a light of
similar characteristic and power. It is sug-
gested to use Osram PARATHOM SPE-
CIAL T26 0.8 Watts.
5. Install the lamp cover.
6. Connect the appliance.
7. Open the door. Make sure that the lamp
comes on.
8
www.zanussi.com
Содержание ZRA33400WA
