13
Fig. 6
Lay the panel face
down (Fig. 6).
Position the top
bracket on the
panel, making
sure that there is
an equal distance
between it and
the sides and that
its distance from
the top edge is equal to distance (A) less 1 cm.
Secure the bracket with the screws supplied.
Take care not to damage the front face of the panel
whilst working.
Fig. 7
Insert the
adjusting pins (B-
Fig. 7) into their
locations in the
door and screw
them in.
Fig. 8
Hook the
decorative panel
onto the top part of
the door, inserting
the pins (B) (on the
door) into the
elongated holes (1)
(in the top bracket
fitted to the panel)
(Fig. 8).
Insert the securing screws (C) through elongated
holes (2) and fix the panel without tightening the
screws (Fig. 8).
Fig. 9
Once the top of
the panel has
been correctly
positioned, fix it
through the holes
in the bottom
bracket, without
tightening the
screws (Fig. 9).
D468
A
-1cm
=
=
D532
B
D533
1
B
2
C
D471
Fig. 10
Check the
position again by
slackening the
screws and pins
then, once the
best position has
been obtained,
fully tighten all
the fixings.
Cover the visible
part of the top bracket on the panel with plastic
cover (D), inserting it in the locations provided in
the bracket.
Fig. 11
Once the door has
been correctly
aligned, tighten
the holding nuts
on the fixing
brackets and
attach the
appliance to the
adjacent units and
the bottom of the
work surface
(Fig. 11).
Fig. 12
If the appliance
has been fitted into
a space 820 mm
high and the
maximum height
of the base plate is
100 mm, fit the
front cover plate
by pushing the two
vertical lugs into
the rectangular holes on the bottom side of the
ventilation duct until they click. The plate can be
adjusted backwards or forwards in the holes
(Fig. 12).
D472
D
D517
135
185
170
220
600
820
870
D518
