12
Location
Fig. 1
This appliance is
designed to be
built-in to a space
having the
dimensions given
in Fig. 1.
Fig. 2
The height of the
appliance can be
altered if required
by means of
adjustable feet
situated at its
base (Fig. 2).
Door reversibility
Remove the two screws which fix the upper hinge to
the door.
Fig. 3
Carefully lean
the appliance on
its back and
remove the plastic
insert (Fig. 3).
Remove the two screws which fix the lower hinge to
the door.
Remove the four screws which fix the lower hinge
to the base of the appliance and remove the hinge
itself; be very careful to recover all the screws.
Remove the four screws that fix the upper hinge to
the appliance and remove the hinge itself.
100-170
596
820-870
547
550
600
820
870
D506
D507
D447
Fig. 4
Take the hinge
removed from
the upper part of
the appliance on
the opposite side
(see Fig. 4), and,
using the screws
removed from the
lower part, fix it to
the base of the
appliance itself.
Remove and refit the other hinge on the upper part
of the appliance on the opposite side.
Fix the two front screws into the upper and lower
hinges (Fig. 4).
Finally, check the alignment of the door and make
sure it closes properly.
After having reversed the opening direction of the
door, discard the original plastic insert removed and
fit the insert supplied with the appliance on the
opposite side.
Fitting a decorative door panel
Important: The components needed to fit the decorative
panel have been pre-fitted on the appliance.
The brackets are secured to the panel by means of the 7
Ø 3.5x13 screws supplied.
Before starting to fit the panel, remove the large top
bracket by unscrewing the screws and adjusting pins pre-
fitted on the appliance door. The small bottom bracket
need not be removed.
Fig. 5
Place the
appliance in the
position where it
is to be built in
(Fig. 5).
The appliance is
fitted with
adjustable feet;
screw the front
and rear feet in
or out to adjust the height of the appliance to that of
the recess.
Keeping the appliance central in the recess, slide it
in until its back touches the wall.
With a tape measure (or similar instrument),
measure distance (A) between the top edge of the
door and the top edge of the decorative panel,
placing it next to the recess.
D510
D467
=
=
A
