Zanussi ZPC 426 D, Инструкция пользователя

Страница: 4 / 10

12
INSTALLATION
If this appliance featuring magnetic door seals is to
replace an older appliance having a spring lock (latch) on
the door or lid, be sure to make that spring lock
unusable before you discard the old appliance. This will
prevent it from becoming a death-trap for a child.
Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
Best performance is obtained with ambient
temperature b18
°
C and +43
°
C (class T);
+18
°
C and +38
°
C (class ST); +16
°
C and +32
°
C (class
N); +10
°
C and +32
°
C (class SN).
The class of your appliance is shown on its rating plate.
For building into kitchen units follow the special
“Building-in” instructions given.
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply.
Voltage can vary by
±
6% of the rated voltage.
For operation with different voltages, a suitably
sized auto-transformer must be used.
The appliance must be earthed.
The power supply cable plug is provided with a
contact for this purpose.
If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in
compliance with current regulations, consulting a
specialist technician.
The Manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with EEC directive number
87/308 of 2/6/87 relative to radio interference
suppression.
This appliance complies with the following
E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
-
89/336 EEC
of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
Cleaning the interior
Before using the appliance for the first time, wash
the interior and all internal accessories with
lukewarm water and some neutral soap so as to
remove the typical smell of a brand-new product,
then dry thoroughly.
Do not use detergents or abrasive powders, as
these will damage the finish.
Door reversibility
This appliance is equipped to allow the opening
direction of the doors to be changed. To do this:
Position the appliance horizontally.
Unscrew the middle hinge (A) and remove it,
slightly lifting the doors.
Remove the top door, unscrew the top screw (1) and
remove it with its washer (2).
Remove the stud (3) and fit it on the opposite side
using screw (1) and its washer (2).
Reposition the door.
Remove the bottom door. Remove the three screws
(5) which secure the hinge to the cabinet. Slowly
slide the hinge out of the slot in the bottom
ventilation grille. Turn the hinge upside down;
position it and screw it on the opposite side.
Refit the bottom door.
Remove the screws which blank off the holes, then
position the middle hinge on the opposite side,
slightly lifting the doors, making sure that the doors
are properly aligned.
Fig. 1
Fig. 2
D148
A
D150
1
2
3
4