47
1
2
3
4
FO 2570
Fig. 22
1
- Screw
3
- Washer
2
- Washer
4
- Burner
Fig. 20
• Remove the adhesive gasket which is
attached to the bottom surface of the hob
top (Fig. 19)
•
Place the sealing gasket which supplied
with the appliance onto the front, left and
right borders of the opening for the gas
hob, as shown in Fig. 20. Take care that
the edges meet precisely without
overlapping.
• The earth connection between the hob top
and the built-in oven is obtained by means
of the green/yellow wire. Connect the wire
to the connection tab located in the
bottom side of the hob top (marked with
the symbol
- Fig. 21).
•
Securing the stainless steel hob top:
place the hob top onto the opening and
fix it to the gas burners with two fixing
screws each (Fig. 22 - n. 1)
•
Securing the enamelled hob top:
place the hob top onto the opening and
fix it to the gas burners with two fixing
screws and four washers each (Fig. 22 -
n. 1, 2 and 3).
Do not use electrical screwdrivers for
this operation, to avoid damages to
the hob top or the burner body. Use
a proper cross-tip screwdriver.
• Place the burner crown and burner caps
onto their housing. Place the pan supports
as well.
• Finally, carry out a functionality test.
Fig. 21
