18
IMPORTANT!
If an option which is not compatible with the set
wash programme is selected, the message
Err
is displayed for few seconds and the
red
light
of this button flashes for 3 times.
Altering an option or a running programme
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause
the washing machine by pressing button
8
.
Changing a running programme is possible
only by resetting it. Turn the programme
selector dial to «
O
» and then to the new
programme position. Start the new programme
by pressing button
8
again.
The washing water in the tub will not empty
out.
Interrupting a programme
Press button
8
to interrupt a programme which
is running, the corresponding light starts to
flash. Press the button again to restart the
programme.
Cancelling a programme
Turn the selector dial to «
O
» to cancel a
programme which is running. Now you can
select a new programme.
Opening the door after the programme has
started
First set the machine to pause by pressing the
button
8
.
If the light
9
goes off, the door can be opened.
If it does not go off, this means that the
machine is already heating, that the water level
is above the bottom edge of the door. In this
cases the door cannot be opened.
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to «
O
». The door can
be opened after a few minutes.
(Pay attention to the water level and
temperature!
).
After this procedure, it will be necessary to set
the programme and the options again and then
to press button
8
.
At the end of the programme
The washer dryer stops automatically. Some
acustic signals sound and on the display will
appear a flashing «
0
». The button
8
light and
the light
9
go off. The door can be opened.
If, at the end of a programme, there is water in
the tub (light
9
still on),
to empty out
the water
follow the following instruction
s
:
To empty out the water:
1. turn the programme selector dial to «
O
»
2. select the
Drain
»or «
Spin
» programme
3. reduce the spin speed, if needed, by means
of the button
2
4. press button
8
5. at the end of the programme, the display
shows a flashing zero «
0
», the light
9
goes
off and it will be possible to open the door.
Turn the programme selector dial to «
O
» to
switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty.
If you do not intend to carry out another wash,
close the water tap.
Leave the door open to prevent the formation
of mildew and unpleasant smells.
Stand By:
If your laundry is not removed within
10 minutes after the programme is finished, the
back light of the display switches off and the
energy saving system will be enabled. Only the
pilot light of the button 8 is blinking to indicate
that the appliance has to be switched off. By
pressing any button the appliance will come
out from the energy saving status and you can
set another programme or switch the appliance
off.
132960310.qxd 23/10/2008 12:09 Pagina 18
