Zanussi ZK 20/10 R, Инструкция

Страница: 12 / 18

GB
30
Possible cause
Thermostatic control can be set wrongly.
If products are not cold enough or
placed wrongly.
The door does not close tightly or it is not
shut properly.
Thermostatic control can be set wrongly.
The door does not close tightly or it is not
shut properly.
Products in big quantity to be frozen
were put in.
Products to be frozen are placed too
closely to each other.
It is normal. During automatic defrosting
frost melts on the back plate.
The outlet of the chamber can be
clogged up.
Products placed in can prevent water
from flowing into the collector.
The melting water outlet flows not into
the evaporative tray above the
compressor.
Products are not wrapped properly.
Doors are not shut properly or do not
close tightly.
The thermostatic control can be set
wrongly.
The thermostatic control is set wrongly.
Doors are not shut properly or do not
close tightly.
Products in big quantity to be frozen
were put in.
Too warm food was put in.
The appliance is in too warm place.
Plug is not connected to the mains
socket properly.
The fuse burnt out.
The thermostatic control is not on.
There is no voltage in the mains socket.
(Try to connect another appliance into it.)
The appliance is not supported properly.
Solution
Set the thermostat knob to higher
position.
Place the products to the appropriate
place.
Check if the door closes well and the
gasket is unhurt and clean.
Set the thermostat knob to higher
position.
Check if the door closes well and the
gasket is unhurt and clean.
Wait some hours and then check the
temperature again.
Place the products in a way so that
cold air could circulate among them.
Clean the outlet.
Replace the products so that they can
not touch the back plate directly.
Put the melting water outlet to the
evaporative tray.
Wrap the products better.
Check if the doors close well and the
gaskets are unhurt and clean.
Set the thermostat knob to a position
that gives higher temperature.
Set the thermostat knob to a position
that gives higher temperature.
Check if the doors close well and the
gaskets are unhurt and clean.
Wait some hours and then check the
temperature again.
Put food at max. room temperature.
Try to reduce the temperature in the
room where the appliance stands.
Connect the mains plug properly.
Change the fuse.
Start the appliance according to
instructions in chapter 'Putting it into
use'.
Call an electrician.
Check if the appliance stands stable
(all the four feet should be on the
floor).
Problem
It is too warm in the
refrigerator.
It is too warm in the
freezer.
Water flows at the back
plate of the refrigerator.
Water flows into the
chamber.
Water flows onto the
floor.
There are too much frost
and ice.
The compressor
operates continually.
The appliance does not
work at all. Neither
cooling, nor lighting
works. Indicator lamps
do not give light.
The appliance is noisy.
Inasmuch as the advice does not lead to result, call the nearest brand-mark service.