Zanussi ZFT610X, Инструкция

Страница: 12 / 16

12
Levelling
The appliance must be level. Level the appliance by
adjusting the two adjustable feet (1) at the front of the
appliance.
If required the washer (2) can be removed.
Door Reversal
If required the opening direction of the door can be
changed as follows:
Disconnect the appliance from the electricity supply.
Tilt the appliance backwards, resting the top edge of
the appliance on a stool or something similar.
Unscrew the adjustable feet situated on both sides at
the front (2 pieces). Remove the lower door hinge
plate by unscrewing the 2 retaining screws.
Remove the hinge pin from the bottom of the door.
Slot the hinge pin into the hole in the hinge plate.
Take the door off.
Refit the upper hinge pin into the opposite location.
Fit the door in place on the hinge pin.
Slot the hinge pin into the hole in the hinge plate and
relocate the hinge assembly to the opposite location
and refit using the retaining screws.
Refit the bottom hinge plate assembly on the oppo-
site side, taking care that the edge of the door is par-
allel with the side of the cabinet.
To reverse the handle proceed as follows:
Remove screw covers (if fitted) and handle retaining
screws. Remove blanking plugs on the opposite side
using a punch.
Relocate the handle to the opposite side and refit
retaining screws (covers if fitted), and push the plas-
tic plugs supplied with the instruction book into the
holes where the handle was previously fitted.