1
2
Set switch to position 1 or
2.
Electronic adjustment
The water softener is set at the factory at level 5.
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold function buttons B and C until the
indicator lights for function buttons A, B and C start
to flash.
4. Release function buttons B and C.
5. Press function button A.
– The indicator light for function button A continues
to flash.
– The indicator lights for function buttons B and C
go off.
– The end indicator light starts to flash.
– You can hear an audible signal.
The setting function of the water softener is activated.
The end indicator light flashes and an audible signal
operates to show the level of the water softener. The
pause is approximately 3 seconds.
Example: 5 flashes / 5 intermittent audible signals -
pause - 5 flashes / 5 intermittent audible signals -
pause - etc... = level 5
6. Press the function button A one time to increase the
water softener level by one step.
7. Press the on/off button to save the operation.
Use of dishwasher salt
Caution! Only use dishwashers salt. Types of salt
that are not applicable for dishwashers cause
damage to the water softener.
1
2
3
Fill the salt container with
1 litre of water (only the
first operation).
4
5
6
It is normal that water overflows from the salt con-
tainer when you fill it with salt.
Make sure that there is no grain of salt outer of the
salt compartment. Salt which stays on the tank for
a while drills the tank. It is recommended to start a wash-
ing programme immediately after you fill the salt con-
tainer. This prevents of corrosion because of spilled salt.
When you set electronically the water softener to level 1,
the salt indicator light does not stay on.
23
