27
Clean the external surfaces of the machine and control panel
with a damp soft cloth. If necessary use only neutral
detergents.
Never use abrasive products, scouring pads or solvent
(acetone, trichloroethylene etc....).
Ensure that the seals around the door, the detergent and rinse
aid dispensers are cleaned regularly with a damp cloth.
We recommend every 3 months to run a 65°C wash
programme without dishes using detergent.
Cleaning the central filter
(After each wash)
Scraps of food may accumulate in the drain filter (A) and
should be removed by rinsing the filter under running water.
To remove the drain filter
- simply pull it out by the handle
Once cleaned, refit the filter by pushing it back to its original
position until it engages.
Cleaning the large filter
(Every week)
If necessary clean the large filter (B) on both sides under
running water, using a brush.
To remove the large filter
1. Remove the spray arm by pulling it upwards.
2. Turn the column (C) anticlockwise by 90° and then slide out
the filter.
3. Once cleaned refit it following the above instructions in
reverse order.
4. Ensure that the filter is in its original position, the handle of
the drain filter should be pointing towards the front of the
appliance.
The dishwasher must not be used without filters. Incorrect
repositioning and fitting of the filters will produce poor
washing results. Cleaning the filters is vital to ensure
correct operation of the machine.
To ensure a correct
working of the dishwasher,
NEVER try to remove the
upper spray arm.
If residues of soil have
clogged the holes in the
upper spray arm, remove
them with a toothpick.
Prolonged periods of non-operation
If you are not using the machine for any period of time you are
advised to:
1. Unplug the appliance and then turn off the water.
2. Fill the rinse aid dispenser.
3. Leave the door ajar to prevent the formation of any
unpleasant smells.
4. Leave the inside of the machine clean.
Frost precautions
Avoid placing the machine in a location where the temperature
is below 0°C. If this is unavoidable, empty the machine, close
the appliance door, disconnect the water inlet pipe and empty
it.
Moving the machine
If you have to move the machine (moving house etc....):
1. Unplug it.
2. Turn the water tap off.
3. Remove the water inlet and discharge hoses.
4. Pull the machine out together with the hoses.
Avoid over tilting the machine during transportation.
Maintenance and cleaning
A
MA04
MA19
C
90
°
B
MA05
MA20
MA21
MA18
MA33
All manuals and user guides at all-guides.com
