Zanussi ZDF21001NA, Руководство пользователя

Страница: 14 / 16

Problem and alarm code Possible solution
You cannot activate the appliance. • Make sure that the mains plug is connected to the mains
socket.
• Make sure that there is no a damage fuse in the fuse box.
The programme does not start. • Make sure that the appliance door is closed.
• Press Start.
• If the delay start is set, cancel the setting or wait for the
end of the countdown.
• The appliance has started the procedure to recharge the
resin inside the water softener. The duration of the proce-
dure is approximately 5 minutes.
The appliance does not fill with wa-
ter.
• The indicator
flashes 1 time
intermittently.
• The indicator flashes continu-
ously.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clogged.
• Make sure that the inlet hose has no kinks or bends.
The appliance does not drain the
water.
• The indicator
flashes 2
times intermittently.
• The indicator flashes continu-
ously.
• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or bends.
The anti-flood device is on.
• The indicator
flashes 3
times intermittently.
• The indicator flashes continu-
ously.
• Close the water tap and contact the Service.
Once you have checked the appliance, press . If
the problem occurs again, contact the Service.
For alarm codes not described in the table, contact
the Service.
THE WASHING AND DRYING RESULTS ARE NOT SATISFACTORY
Problem Possible solution
There are whitish streaks or blu-
ish layers on glasses and dishes.
• The release quantity of rinse aid is too much. Adjust the rinse
aid selector to a lower position.
• The quantity of detergent is too much.
There are stains and dry water
drops on glasses and dishes.
• The released quantity of rinse aid is not sufficient. Adjust the
rinse aid selector to a higher position.
• The quality of the rinse aid can be the cause.
14