6
3.2 INSTALLATION OF OVEN
There are some factors that must be paid attention to while installing your oven. Surely
pay attention to while installing your oven. Surely pay attention to our below suggestions
in order to be able to prevent any problems and/ or dangerous situations that may
occur later.
It can be placed close to other furniture on condition that in the area where the oven
is set up, the furniture’s height must not exceed the height of the cooker panel.
Pay attention not to place it near the refrigerator, there must be no flammable or
inflammable materials such as curtain, waterproof cloth,.....etc. that will begin to burn
quickly, while selecting place for oven.
It is required there must be least 2 cm blank space between the back cover of oven and
wall for air circulation.
The furniture close to oven must be manufactured resistans to heat more than 500C
of the room temperature.
If the kitchen furniture are higher than the pan which the oven’s cookers are on, it must
be at least 11cm away from the oven’s side.
The minimum heights from the oven’s pan and wall cupboards and cooker hoods with
fan over the oven, are shown as below. Thus, the paddle box must be at minimum 650mm
height from the cooker pan (Figure 5)
I f t h er e i s n o co o ke r h oo d , t hi s h ei gh t m us t n ot be le ss t h an 70 0m m.
3.3 ADJUSTMENT OF FEET
Your oven stands on 4 adjustable feet. As the feet are adjusted in low location, it is
required to control whether it is balanced before installing the oven. You can make this
adjustment as turning the feet clockwise if required. It is possible to raise the apparatus
maximum 15mm via the feet. If the feet are adjusted appropriately, it is required not to
move the apparatus by dragging, otherwise it is required to place it by lifting it up.
3.4 MOUNTING OF GAS HOSE AND IMPERVIOUSNESS CONTROL
The gas of apparatus must also be connected in accordance with standards. The adjusted
gas type of apparatus must be determined on the type signboard on the back of the
apparatus. You can find the information related to appropriate gas types and appropriate
gas injectors on technical data table. Pay attention that the feeding gas pressure must be
appropriate for the values on technical data table to be able to get the most efficiency and
to ensure the least consumption. If the pressure of used gas is different than these values
or changeable, it is required to affix an available pressure regulator on the entrance pipe. It is
surely required to contact to the authorized service to make these adjusments.
