10
Cleaning and maintenance
Replacing the Oven Light
Ensure the electricity supply is switched off before
carrying out this operation.
The oven bulb has to comply to these features:
a) resistant to temperatures of 300 °C;
b) electric rate: 230 V - 50 Hz;
c) electric power rate: 15 W.;
d) connection type: E 14.
To replace the bulb, proceed as follows (Fig. 6):
a)
push in and turn the glass lid anticlockwise;
b)
remove tha faulty bulb;
c)
replace it with a new one;
d)
refit the glass lid;
e)
switch on the electricity supply.
General Cleaning
Before cleaning, always allow the oven to
cool
down.
When using
spray
cleaning products, be careful not to
spread them on the heating elements or on the thermostat
sensor.
Never use harsh
abrasives
, steel wool or cleaners with
bleach
, as they could damage the enamel and the oven
door glass.
The Oven Cavity
The enamelled oven cavity is best cleaned whilst the oven
is still warm. It is advisable to wipe the oven over with a soft
cloth soaked in warm soapy water after each use. However,
from time to time, it will be necessary to do a more complete
cleaning, using a proper oven cleaner.
In case of particularly tough stains, you can use stainless
steel cleaning products or some warm vinegar.
The Oven Door and its gasket
Before cleaning the oven door, we recommend you to
remove it from the oven.
Proceed as follows:
a)
open the oven door completely;
b)
find the hinges linking the door to the oven (Fig 5);
c)
unlock and turn the small levers located on the two
hinges (Fig. 5);
d)
handle the door by its left- and right-hand sides, then
slowly turn it towards the oven until it is half-closed;
e)
gently pull the oven door off its site (Fig. 5);
f)
place it on a steady plan.
Clean the oven door glass with warm water and a softh cloth
only.
Once the cleaning is carried out, refit the oven door, following
the procedure in reverse.
The correct operation of the oven is ensured by a gasket
placed round the edge of the oven cavity.
Periodically
check
the condition of this gasket. If
necessary, clean it without using abrasive cleaning
products.
If the gasket shows to be
damaged
, call you local
Zanussi Service Centre. Do not use the oven until it has
been repaired.
FO 0287
FO 0288
Fig. 6
Fig. 5
Care of catalytic liners
(Mod. ZBM 775)
Catalytic liners destroy splashes of food and fats when
the oven temperature is raised to around 220°C.
To aid this process it is a good idea to run the oven for
an hour or two per week, without food, to ensure
continued good performance from the Catalytic liners.
Hints and Tips
Manual cleaning of the Catalytic liner is not
recommended. Damage will occur if soap
impregnated steel wool pads, aerosol cleaners and
any other abrasives are used.
Slight discoloration and polishing of the Catalytic
surface may occur in time. This does not affect the
Catalytic properties in any way.
Follow the recommendations below to keep oven
soilage to a minimum.
