12
Stitch width is to be chosen arbitranly with in between 0 and 1 range according to varia-
tion of stitch length. (1) For thicker stitching, adjust selection dial to "O". Satin stitches suit light-
weight material. (2) For thicker stitching, adjust selection dial to "1”.
Loose stitches suit heavyweıght material.
Instructron: Make trial stıtchıng on some small cloth so as to find out the optimum effect.
(1) Make the marks of buttonhole carefully on the material. (2) Pull forward slide (A),keep the mark (C)on it in conformity to the
initial mark (B),The mark on the presser foot should be aligned with that of the material Lower the presser foot.
Instruction: marks on the slide should be carved in cm. (3) Adjust stitch selection dial to. Keep stitching forward until come to
the marks in front of the buttons and then stop sewing with needle pausing at top left. (4) Adjust stitch selection dial to Make 4-6
stitches before stopping sewing with needle pausing at top right. (5) Adjust stitch selection dial to Keep stitching backward until
come to the marks at the back of buitons and then stop sewing with needle pausing at top right. (6) Adjust stitch selection dial to
Make 4-6 stitches before stopping sewing with needle pausing at top left. (7) After sewing: buttonholes, take out fabrics. Insert a
pin at the back hole of buttonhole so that the end of thread of buttonhole will not be cut off mis takely. Cut out the buttonhole
carefully with a buttonhole cutter.
BUTT
BUTT
ONHOLES WITH DECORA
ONHOLES WITH DECORA
TIVE STITCHING
TIVE STITCHING
(1) pattern selection dial:BH
(2) stitch length: IIIIIIIIII (0,5-1)
(3) presser foot: making buttonholes
(4) thread tension disc tension: 3-5
1. Raise the foot plate of buttonholes sewing hang the laid in threads on the cam at the back of
presser foot, (1) Positioning cam 2. Draw forward the end of additional thread under the presser
foot and place it under the center of presser foot. 3. Hold tightly the additional thread and hook the fork in
front of the presscr foot. 4. Bring the neddle into the fabrics before starting sewing and lower the presser foot.
5. Slowly step down foot controller buttonholes, with each face of buttonholes encasing the laid-in threads
6.Take out fabrics and clip sewing thread. 7. Pull the laid-in threads from left side and hold it tightly.
8.The end of thread should be wound to darning needle. Draw the thread to the back and clip.
Instruction: while cutting out buttonholes, pay attention to the instruction on Page 12.
BUTT
BUTT
ONHOLES
ONHOLES
(1) satural pattern selection dial:
see the drawing 1
(2) stitch length:
(0,5-1)
(3) presser foot: making buttonholes
(4) thread tension disc tension: 3-5
Anl.790.GB/SE/DK/FI/CZ/HU 13.09.2006 13:33 Uhr Seite 14
