Zanussi WTJ 1074 H, Инструкция по эксплуатации

Страница: 18 / 21

18
FOR THE INSTALLER
Technical information
Dimensions height with panel 895 mm
height without panel 850 mm
width 450 mm
depth 600 mm
Power supply voltage / frequency 220 V / 50 Hz
Total power absorbed 2200 W (10 A)
Heater rating for washing 1950 W
Heater rating for drying 1320 W
Water pressure minimum 5 N/cm² (0,5 kg/cm 2 )
maximum 80 N/cm² (8 kg/cm 2 )
Maximum load for washing : cotton 5 kg
synthetics 2,5 kg
wool 1 kg
Maximum load for drying : cotton 2,5 kg
synthetics 1,5 kg
Spinning speed 1000 rpm
Electrical consumption (washing at 60°C) 1,2 kWh
This appliance complies with the following EC Directive :
- 72/23/EEC of 19.02.1973 - Low-Voltage Directive
- 89/336/EEC of 03.05.1989 (including Amentment Directive 92/31/EEC) - EMV Directive.
Installation
Unpacking
The parts protecting the inner components of
the machine during transit are red. They must
all be removed before using your machine for
the first time. These parts and their securing
means should be kept in case the machine
has to be transported again.
Unpack the appliance. Tilt the appliance
backwards. Give to one of the back corners a
quarter turn. The appliance comes free naturally
out the polystyrene basis. Take away this
basis (fig. 1).
Open the lid of the appliance and remove the
polystyrene wedge which blocks the drum.
Close the lid (fig. 2).
On the back part and with a spanner, remove
the two red loosened spacers (A) (fig. 3).
The holes which are now visible must be closed
with the plugs (B) provided with the appliance
(fig. 4). Do not forget to put the central cover.
Please ensure that these parts have been
removed from the machine and keep them in
case of next transport (fig. 5).
If you want to keep the alignment of your
appliance with the adjacent cupboards, you
have the possibility to cut the crossbar holding
the hoses located at the back of your washer-
dryer machine (fig. 6).
Fig. 1
Fig. 2
Fig 4
Fig 6
B
A
Fig 3
Fig 5