Zanussi GAS AND ELECTROGAS COOKERS, Руководство пользователя

Страница: 23 / 27

51
Adjustment of minimum level of plate burners:
To adjust the minimum level, turn the knob to the
position of minimum flame, remove the knob (Fig. 31)
and: in case of conversion from natural gas to LPG,
tightly screw the by-pass pin of the cocks;
when converting from LPG to natural gas unscrew
about one-fourth turn by-pass pin, until a regular small
flame is reached.
Reassemble the parts following the same procedure
backards.
Check that, turning quickly the knob from the maximum
position to the minimum one, the burner doesn't go out.
Replacement of oven burner nozzle:
To replace the oven nozzle, follow this procedure:
remove the bottom of the oven, unscrew screw 1 (fig.
32) and take the oven burner out.
With a socket spanner 7 unscrew and remove the
nozzle, situated in the bottom of the oven, replacing it
with the proper one (see Table 2); reassemble the
burner following the same procedure backwards.
Fig. 31
Minimum level adjustment of oven burner
In ranges with thermostat, after setting the oven on
maximum temperature with closed door for about 10
minutes, turn the knob of the thermostat on 140,
remove the knob and:
-
in case of conversion from natural gas to LPG,
tightly screw the by-pass pin of thermostat (fig. 31);
- converting from LPG to natural gas, then, unscrew
the by-pass pin, until a regular small flame is
reached.
Fig. 32
Fig. 33
ADJUSTMENT INSTRUCTIONS FOR THE
BY-PASS PIN OF THE OVEN BURNER
THERMOSTAT
In the models equipped with rond head by-pass pin,
operate as follows to adjust such a device:
- take out the knobs;
- remove the frontal;
- adjust xith a thin screwdriver, see figure 33;
- finally check that turning quickly the tap from
maximum position to minimum position, the burner
doesn't switch off.