46
MAINTENANCE
Before each operation, disconnect the unit.
Cleaning the cooker
Drops of sauce, fruit juice etc., should be removed as
soon as possible with a soft cloth soaked in warm
detergent water. Do not use steel wool or knives to take
off layers of crust. Remove stubborn marks with a well
wetted soap impregnated pad, but care must be taken
not to scratch the enamel. Wash the enamelled grids
with water and detergent; these can also be washed a
dishwasher.
Take off the burner covers and the grids and wash
them carefully with warm water and detergent. Dry
them well before putting them back in position.
Moreover, make sure that these are properly re-placed.
The burner can be rubbed with steel wool or a slightly
abrasive cloth.
Clean the oven door and crystal cover, in models
equipped with these items, only with warm water, and
avoid the use of rough cloths or abrasive substances;
in cookers with an automatic ignition the sparkling bulb
should be cleaned periodically and accurately to avoid
difficulties in lighting; furthermore check that the burner
holes are not obstructed.
Cleaning the oven
Clean carefully the oven cavity after use when it is still
warm. In fact, at this moment it is easy to take off
deposits of fat or other substances such as fruit juice,
sugar particles or fat. You can use warm detergent
water or one of the appropriate spray oven cleaners.
Do not direct the spray at the mat steel parts as this
could damage them and always follow the
manufacturer's instructions. Clean the oven acces-
sories (grate, grid-plate etc.) with warm water and
detergent.
Remove possible incrustations with a slightly abrasive
powder.
Never line any part of the oven with aluminium foil.
It would result in an accumulation of heat which
might damage the cooking results and also
damage the enamel.
Controls - Sundries
Periodically check the condition of the flexible pipe of
gas connection and make it replaced by skilled
technicians as soon as it shows abnormalities. Annual
replacement is recommended.
Have the cocks periodically lubricated by skilled
technicians. In case of unusual working have the range
checked by skilled technicians.
In ranges with cylinder holder, do not use this space to
leave a non-connected or an empty cylinder.
Cylinder holder
The units equipped with cylinder holder must be
installed in such a way to ensure a sufficient ventilation
inside the holder itself; otherwise there is the chance
to install inside the holder, instead of the cylinder, (on
request) a set of grills and containers, converting the
cylinder holder into a comfortable closet.
Oven lamp replacement (Fig. 17)
Disconnect the appliance. Unscrew the lamp and
substitute it with another fitting for a higher tempera-
ture (300
°
C) with the folowing characteristics:
Tension:
230 V (50Hz)
Power:
15W
Convection:
E14
Fig. 18
Cleaning the oven door
For a more complete cleaning of the oven door, it is
advisable to disassemble it in the following way (Fig.
18):
open the door fully, turn the two caps situated on the
arm of the hinge to 180
°
partially close the door to an
angle of 30
°
, lift the door and extract from the front.
Re-mount the door by reversing the operation
described above.
Fig. 17
Содержание GAS AND ELECTROGAS COOKERS
Страница 27: ...55 ...
