Zanussi 925503026, Руководство пользователя

Страница: 22 / 52

Problem Possible cause Solution
Water flows on the rear plate
of the refrigerator.
During the automatic de-
frosting process, frost melts
on the rear plate.
This is correct.
Water flows inside the refriger-
ator.
Food products prevent the
water to flow into the water
collector.
Make sure that food products do
not touch the rear plate.
The water outlet is clogged. Clean the water outlet.
Water flows on the floor. The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
Attach the melting water outlet to
the evaporative tray.
The temperature in the appli-
ance is too low/too high.
The temperature regulator is
not set correctly.
Set a higher/lower temperature.
The door is not closed cor-
rectly.
Refer to "Closing the door".
The food products' tempera-
ture is too high.
Let the food products tempera-
ture decrease to room tempera-
ture before storage.
Many food products are stor-
ed at the same time.
Add less food products at the
same time.
The thickness of the frost is
greater than 4-5 mm.
Defrost the appliance.
The door has been opened
often.
Open the door only if necessary.
There is no cold air circula-
tion in the appliance.
Make sure that there is cold air
circulation in the appliance.
If the advice does not lead to the
desired result, contact the nearest
Authorised Service Centre.
REPLACING THE LAMP
The appliance is equipped with a long-
life LED interior light.
It is strongly recommended to use
original spare parts only.
Use LED bulbs (E14 base) only. The
maximum power is shown on the lamp
unit.
CAUTION! Disconnect the plug from
the mains socket.
1. With your fingers, spread slightly both sides of
the transparent cover to unhook them and
detach the cover pulling it in the direction of
the arrows.
22