11
SOLUTION
◆
Check the oven is in manual operation and that both a
cooking function and a temperature have been selected
or
◆
Check the appliance is wired in properly, and the socket
switch or the switch from the mains supply to the oven are
ON.
◆
Turn the thermostat knob on a temperature
or
◆
Turn the oven function control knob on a function.
◆
Turn the oven function control knob on a function
or
◆
Buy a new oven light bulb, asking for it to your local Zanussi
Service Centre and replace it by following the instruction
provided in this booklet.
◆
Refer to the contents of this booklet, especially to the
chapter "Using the Oven".
◆
Leave dishes inside the oven no longer than 15-20 minutes
after the cooking is completed.
SYMPTOM
■
The oven does not come on
■
The oven temperature light does not come on
■
The oven light does not come on
■
It takes too much time to finish the dishes, or they are
cooked too fast.
■
Steam and condensation settle on the food and the
oven cavity.
If the appliance is not working correctly, please carry out the following checks, before contacting your local
Zanussi Service Centre.
7. What happens if something goes wrong
Replacing the Oven Light
•
Ensure the electricity supply is switched off before
carrying out this operation.
The oven bulb has to comply to these features:
a) resistant to temperatures of 300
°
C;
b) electric rate: 230 V - 50 Hz;
c) electric power rate: 25 W.;
d) connection type: E 14.
To replace the bulb, proceed as follows:
(fig.13)
a) push in and turn the glass lid anticlockwise;
b) remove tha faulty bulb;
c) replace it with a new one;
d) refit the glass lid;
e) switch on the electricity supply.
The Hinged Grill
This model has been fitted with a hinged grill element,
to enable you to clean the roof of the oven easily.
Before proceeding, ensure the oven is isolated from
the electricity supply. Then undo the screw which holds
the grill in place. (see Fig. 10)
Gently pull the grill downward to allow access to the
oven roof. (see Fig. 11).
Clean the oven roof with a suitable cleaner and wipe
dry before replacing the hinged grill element.
Gently push up the grill element into place and firmly
screw into place the holding nut.
NOTE: Ensure the grill holding nut is firmly in place
to avoid the grill falling down during operation.
Grease Filter
When cooking meat, the grease filter must be fitted
over the oven fan by clipping it over the vents in the
back panel. This will prevent a built-up of fat on the fan
impellor. Do not use abrasive materials to clean the
seal. The grease filter is dishwasher proof.
When cooking is completed and the oven has cooled
down, remove the filter by pushing the protruding
tongue on the filter upward.
(See Fig. 12)
