_______________________________________________7. WORKING ELECTRONIC VERSION
______________________________________________________________________________
23
CITIZEN 6 - 9/MC
7.3.5.Key
chamber light
By pressing the key of the chamber light
you activate the turning on of
the lamp placed inside the baking chamber. By pressing it again, you
deactivate it.
7.3.6.
Switch for suction hood
The switch for suction hood control
is placed on the side part of the control
panel, on the upper side (Pos.1 of Fig. 7.2).
Push this switch on position "I" to start one of
the two motors of the suction hood.
Push this switch on position "II" to start both
motors of the suction hood.
Push this switch on position 0 to stop it.
7.4.Alarms
7.4.1.Overtemperature alarm
If the chamber exceeds 500°C owing to a failure, the system will block the
current cycle immediately.
The electromagnetic switch will inhibit the oven functions. The blinking writing
"tS1" will be shown on the display
.
To reset the alarm and enable the system again, press the key
twice
after detecting the failure.
If you reactivate the oven operation before the temperature has fallen below
500°C, the alarm will appear again.
In any case have the oven checked by a technician to eliminate the cause for
the alarm before using the oven again.
7.4.2.Disconnected probe
When the probe is disconnected or interrupted, the blinking writing "tS1" is
shown on the display
.
To reset the alarm and enable the system again, press the key
twice
after detecting the failure.
In any case have the oven checked by a technician to eliminate the cause for
the alarm before using the oven again.
Pos.1
Fig.7.2