ZANKER ZSK3502X, Инструкция по установке и эксплуатации

Страница: 11 / 16

31
76
26
In respect of the protection of surrounding surfaces
from overheating, this appliance is of type Y: this ap-
pliance, and the kitchen unit in which the appliance is
installed, can be installed in conjunction with a glass
ceramic cooking surface or hob with the rear wall and
one side wall against walls or units of any height, with
the other side against another appliance or unit of the
same height as the appliance.
Fitting
Please note the informations on the rating
plate, these informations are in case of a ser-
vice call important.
The front of the unit in which the cut-out for the built-in
switch box is to be cut must be a minimum of 16 mm
and a maximum of 22 mm thick.
1. Saw a 80 x 377 mm cut-out in the front of the unit.
2. Remove the ring switches and cover from the ap-
pliance.
3. Open the cover on the terminal box. Lay the con-
nection cable to the terminal box and connect in
accordance with the ”Electrical Connection” sec-
tion.
4. Guide the appliance at an angle into the cut-out,
place in position and align.
5. Using the screws supplied, fix the two brackets so
that the built-in switch box is firmly secured.
6. Clip the panel back on.
7. Slide in the ring switches.
If necessary the additional support bracket can also be
fitted.