ZANKER GE 66005, Руководство пользователя

Страница: 3 / 36

• Make sure that the spray arms can move freely be-
fore you start a washing programme.
• If you open the door while the appliance is in oper-
ation, hot steam can escape. There is a risk of skin
burns.
• Do not remove the dishes from the appliance before
the end of the washing programme.
Care and cleaning
• Before maintenance, switch off the appliance and
disconnect the mains plug from the mains socket.
• Do not use flammable products or products that can
cause corrosion.
• Do not use the appliance without the filters. Make
sure that the installation of the filters is correct. An
incorrect installation causes unsatisfactory washing
results and damage to the appliance.
• Do not use spray water or steam to clean the appli-
ance. Risk of electrocution and damage to the ap-
pliance.
Installation
• Make sure that the appliance has not suffered any
damage while in transport. Do not connect a dam-
aged appliance. If necessary, contact the supplier.
• Remove all packaging before first use.
• Only a qualified person must do the electrical and
the plumbing installation, the set up and the main-
tenance of the appliance. This to prevent the risks
of structural damage or physical injury.
• Make sure that the mains plug is disconnected from
the mains socket during installation.
• Do not drill into the sides of the appliance to prevent
damage to hydraulic components and electrical
components.
Frost precautions
• Do not install the appliance where the temperature
is below 0°C.
• The manufacturer is not responsible for frost dam-
age.
Water connection
• Use new hoses to connect the appliance to the water
supply. Do not use used hoses.
• Do not connect the appliance to new pipes or pipes
not used for a long time. Let the water flow for some
minutes, then connect the inlet hose.
• Make sure not to squash or cause damage to the
water hoses when you install the appliance.
• Make sure that the water couplings are tight to pre-
vent a water leakage.
• The first time you use the appliance, make sure that
the hoses do not have water leaks.
• The water inlet hose is double-walled and has an
inner mains cable and a safety valve. The water inlet
hose is under pressure only when the water flows.
If there is a leak in the water inlet hose, the safety
valve interrupts the running water.
– Be careful when you connect the water inlet hose:
– Do not put the water inlet hose or the safety
valve in water.
– If the water inlet hose or the safety valve are
damaged, immediately disconnect the mains
plug from the mains socket.
– Contact the service centre to replace the water
inlet hose with safety valve.
Warning! Dangerous voltage.
Electrical connection
• The appliance must be earthed.
• Make sure that the electrical data on the rating plate
agree with your domestic power supply.
• Always use a correctly installed shockproof socket.
• Do not use multi-way plugs, connectors and exten-
sion cables. There is a risk of fire.
• Do not replace or change the mains cable. Contact
the service centre.
• Make sure not to squash or cause damage to the
mains plug and cable behind the appliance.
• Make sure that the mains plug is accessible after the
installation.
• Do not pull the mains cable to disconnect the appli-
ance. Always pull the mains plug.
3