13
Technical data
GB
Installation
ELECTRIC HOTPLATES
ø 145 mm 1,2 kW - Normal hotplate
1,2 kW - Halogen hotplate
ø 180 mm 1,8 kW - Normal hotplate
1,8 kW - Halogen hotplate
Type “X” hobs
EQUIPMENT
Depending on the models, hobs may have:
- One or more halogen hotplates
For the LAYOUT OF THE HOTPLATES ON
THE HOB see figure 1 at the back of this
manual.
For the ELECTRIC WIRING DIAGRAM see
figure 2 at the back of this manual.
The electrical power is stated on the name-
plate underneath the hob.
A copy of the nameplate is glued to the cover
of this manual.
INSTALLATION
The appliance must be installed by qualified
staff working in accordance with the regula-
tions in force.
You are advised to read these instructions
for use carefully; they contain important in-
formation which ensures the safety of the
installation. Keep these instructions in a safe
place.
After removing the packaging, ensure that
the appliance is not damaged:
- in particular, the ceramic glass hob must
not be broken or cracked;
Keep all the parts of the packaging (plastic
bags, polystyrene etc.) out of reach of chil-
dren, since they are a source of potential
danger.
POSITIONING (fig. 3)
Place the hob well away from items of furni-
ture taller than the hob for built-in installa-
tion. Any partition parallel to the hob must
be at least 1 cm lower than the box unit in
which it is installed, and a square opening
with sides of 10 cm must be made under the
outlet of the power supply cable.
The ceramic hob can be inserted in all kind
of table tops (brickwork, metal, wood) pro-
viding they resist to a temperature of 120°
C. The sizes of the hole to be cut in the
worktop can be seen in figure 3.
FIXING
A self-adhesive seal (A) is supplied with the
hob. This must be placed under the edge of
the box unit, as close as possible to the edge
itself (fig. 4). The seal must run all round the
unit to ensure a perfect seal and prevent
moisture from seeping under the hob.
Fit the spring nuts (B) into the holes in the
box unit (fig. 4).
Place the hob in the hole in the work top,
making sure that the adhesive ensures a
good seal between the edge of the hob and
the surface of the supporting unit (fig. 5) and
conclude fixing by tightening the screws
which secure the hooks (C) into their seats
