SPECIFICATIONS
• Surface-mounted
• Vandal-resistant zinc alloy housing
• 800 TVL resolution
• ¼” CMOS colour camera
• Night-time IR illumination
• Dust and water proof: IP66
• Operating temperature: -30°C to +60°C
• 110° wide-angle camera
• Video output: 1Vp-p75Ω
• Supply voltage: 10-15 V DC
• Input power: 2.5 W
• Integrated 125 KHz ID reader
• Compliance with Wiegand 26 / ID
• Dimensions: 128x43x16 mm
PRODUCT
DESCRIPTION
1. Microphone
2. Camera
3. Night-time IR illuminator
4. RFID proximity reader
5. Call button
6. Speaker
INSTALLATION
1. Use the wiring connection diagram and verify that all wiring
connections are correct.
2. Choose a suitable location in which to install the entrance panel.
An installation height between 1.5 and 1.6 m above the ground is
recommended.
3. The entrance panel video camera should be away from direct
sunlight and deep shadows.
4. Verify that the power supply voltage is OFF before wiring the
device.
5. Switch on the supply voltage of the device when completely
installed.
6. Seal the back plate edges of the entrance panel of the complete
installation surface with a waterproof silicone product during the
installation. This will prevent condensation occurring between the
entrance panel and its installation surface in certain weather
conditions. Condensation on the surfaces causes a risk of
corrosion of the electronic components in the device and
mechanical stress from freezing of the condensation at low
temperatures.
INSTALLATION DIAGRAM
A. Directly on a wall or a post
1. Select the installation height of the entrance panel and drill the
mounting holes on the installation surface at the desired height.
2. Remove the bracket by removing its lock screw.
3. Mount the bracket on the installation surface with wall plugs and
their screws.
4. Pass the connection wiring end through the bracket and connect
it to the entrance panel wiring. Follow the wiring connection
diagram.
5. Install the entrance panel on the bracket with the lock screw.
