ZALMAN RESERATOR 2, Инструкция по установке и эксплуатации

Страница: 13 / 18

13
English
RESERATOR 2
※
The specifications of any product may change without prior notice to improve performance.
5. 13 Confirm Proper Installation
1) Check that the product is placed properly.
2) Confirm that the coolant circulation path is correct as shown below.
3) Lightly tug the PVC tube connected to each of the fittings to check for loose ends.
5. 14 Leakage Inspecting and Test Run
1) Supply power to the Reserator’s AC cable, and check to see if the green wire terminal
and the black wire terminal of the power supply’s main connector are connected to each
other with Jump Cable.
2) Check the amount of coolant inside the Reserator’s Reservoir, and fill it by approximately 70%.
3) Connect the power supply’s 4-Pin connector to the Reserator’s DC cable connector,
and provide power for the Power Supply by switching its ON/OFF button to ON.
4) Once the power is supplied, check to see if the flow indicator's impeller placed inside the
Reserator’s front panel is rotating, if the Blue LED is lit, and if the coolant is being circulated
to each water block.
Reserator OUT CPU Water Block
N/B Water Block
VGA Water Block
RAM Water Block Reserator IN
Flow Indicator
Heat Sink
Radiate
Heat
Absorb
Heat
Water Pump
CPU Water Block
VGA Water Block
VGA RAM Water Block
5. 12 Installing the VGA RAM Water Block
1) To install the VGA RAM Water Block, connect as shown in the diagram below.
2) Remember to install Tube Clamps on the PVC Tubes during installation.
All manuals and user guides at all-guides.com