The ZAGI-400 Complete Kit Electric Wing Kit contents:
2
Expanded polypropylene (EPP) leading edges
laminated to 1# white foam wing panels and beds
2
Pre-cut balsa elevons
2
24’’ strips of 1’’ x 3 mil paper backed Mylar hinge tape
1
Roll 2.2 mil color poly tape
2
Control horns with 4 screws
2
Threaded 2 X 56 push rods
2
Threaded 2 X 56 clevises
2
Die-cut clear plastic winglets
1
Molded motor mount and battery tray
1
Molded canopy
1
Speed 400 motor and prop
1
Zagi 20 Electronic Speed Control (ESC) with Battery Eliminator Circuit (BEC)
1
7 or 8 cell 500 mAh battery with Deans Ultra plug
2
Tie wraps to secure motor
4
Velcro strips for canopy and battery hold down
1
Deans Ultra plug with red and black leads (for charging the battery)
Needed Components:
1
Mini or micro receiver with crystal for your transmitter channel
Suggestions: Hitec 555 or comparable
2
Mini or micro servos. Suggestions: Hitec HS-81 or HS-85BB; Cirrus CS-20
series, CS-30, or comparable. Servos are available with metal gears (HS-
81MG), providing added protecion from gears stripping on hard impact.
page 3
(See Figure 1)
Separate the top and bottom beds from the wing cores. Lightly block
sand the wing panels (cores) with #150 or #320 grit sandpaper and round the leading edge
(LE).
Beds
Wing Core
Figure 1
