USING THE FLASHLIGHT
Your Power Amp 3 has a bright LED flashlight that’s ideal for lighting any situation.
To enjoy the flashlight feature:
1. Press the flashlight button to turn the flashlight on.
2. Press the flashlight button again to turn the flashlight off.
Note: The LED flashlight will automatically turn off after 10 minutes. Using the
flashlight does not significantly decrease the Power Amp 3’s stored power.
CHECKING THE BATTERY LEVEL
Your Power Amp 3 carries 3000mAh of power to help make sure your battery never
dies again. To check how much power it still carries:
1. Press the battery button. The LEDs under the flashlight will light one
of four ways:
a. Four lights indicate 75% power or more remaining.
b. Three lights indicate between 50-74% power remaining.
c. Two lights indicate between 25-49% power remaining.
d. One light indicates less than 24% power remaining.
2. Recharge your Power Amp 3 whenever you wish.
POWER SAVING TIP
Don’t leave your charging cable plugged into your Power Amp for extended
periods of time. Remove your cable when you’re done charging to preserve
more portable battery power.
For more help, please see our FAQ at: www.zagg.com/faq
To reach a trained customer service representative, please use one of the following:
zagg.com/support/contact.php
[email protected]
1-800-700-ZAGG [9244]
00-1-801-839-3906 for international customers
©2015 ZAGG Inc | All Rights Reserved
NASDAQ: ZAGG | MADE IN CHINA
ZAGG and Power Amp are registered trademarks of ZAGG Intellectual Property Holding Co., Inc.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
