Z3Cam-LX User Instructions
DOC-USR-0155-05
___________________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
44
By default this Z3 device supports 2 fixed profiles for each Camera (Channel), this allows VMS/NVRs' too
see both cameras within a single driver when using ONVIF.
There may be a situation where only one camera is desired to be seen by an ONVIF VMS/NVR. This can be
achieved by going to the
System Setup
tab and clicking on on
Advanced Settings
; The clicking on
Configure ONVIF
within the
Device Management
section of the
System Setup
tab.
Figure 41 System Setup tab configuration
Select 1 from the
Max fixed profiles
drop down selection.
Then click on
change
, you then be asked to reboot the system for the changes to take effect.
The CH1 tab from this point is the designated tab in which ONVIF will work with a camera. To set the
appropriate camera to be used in single profile mode.
Figure 42 Channel 1 Tab configuration
Goto the
CH1
tab and change the
Video Source
to the desired camera.
Start the encoding so the change is pushed to the Z3 device.
