CONFIDENTIAL
DOC-USR-0026-02
___________________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
20
5.5
Ensure your PC has a proper IP address
(8)
To be able to communicate with the board, the PC that you are communicating from needs to have
the same first two parts of the IP address. For example, if the board has an IP address of
192.168.81.68, your PC would need to have an address of 192.168.x.y, where x.y is anything but 81.68
(and not conflicting with whatever is on your current network, of course). Ensure that this is the
case. If necessary, use the “P” and “N” options to modify the address/network of the board to
conform to your network. Note that the first two parts being the same are based on a value of
netmask of 255.255.0.0. If netmask were 255.255.255.0, for example, then the first three parts of
the IP address would have to be the same.
After you are done, make note of the address you set it to. This will be important in the streaming
step.
5.6
Run the Web Interface to Configure CH1
(9)
In your PC, run a web browser (for best results, Z3 recommends FireFox or Chrome). In this browser,
type the IP address of the board noted in step (7) (for example, if the default value is used, it would
be http://192.168.81.68). After about 3 seconds, the control menu should come up:
(10)
Click on the “CH1” tab
(11)
You should see the Channel 1 configuration tab. In this tab, set “Output Format” to UDP and “Dest
Address” to the IP address of your PC (in this example, 192.168.0.6) Also make note of the value of
“Dest Port” (should be 5004 by default):
Figure 7 Web Interface Initial Screen
